1991 Chevrolet Camaro

Complaint history

When NHTSA received these reports. Changes in reporting alone do not establish a change in failure rates.

Problems owners report

Listed groups have at least 3 complaints. The page includes the 20 largest groups plus any additional flagged groups; some complaints are not assigned to a group.

AI groups complaints by meaning; the groups are approximate. Share ratio compares the problem’s share of this vehicle’s complaints with its share on other vehicles over the last 24 months (shown from 3 recent complaints). A 2× ratio means twice the complaint share, not twice the failure risk. Flags mark unusual shares or recent surges after an AI review of the complaint content. “First signal” does not mean the pattern has persisted continuously.How recall estimates are calculated.

Recalls

• NHTSA recall #94V077000April 25, 1994232,988 vehicles affected

  fuel system, gasoline: storage: tank assembly: filler pipe and cap

  The fuel filler neck solder joint Can develop cracks or pin hole leaks, which does not comply with FMVSS no. 301, "fuel system integrity." the cracks and holes Can allow fuel vapor and fuel leakage.

  Consequence of non-compliance: gasoline vapors and fuel leaks Can result in a fire if exposed to a source of ignition.

  Remedy

  Dealers will inspect the fuel tank assembly and replace those which exhibit the cracks or pin hole leaks.

• NHTSA recall #91V074000May 3, 1991173 vehicles affected

  seats: front assembly: recliner

  The front seat upper hinge cover screws are too long, and interfere with the seat back inertia lock. This prevents the seat back from locking properly.

  In the event of a sudden stop or vehicle impact, anunlocked seat back would increase the risk of injury to the seat occupant.

  Remedy

  Replace screws securing upper hinge trim cover with correct length screws.

• NHTSA recall #91V067000April 22, 199140,696 vehicles affected

  seat belts: front: anchorage

  The metal latchplates may not engage the buckle assemblies, causing a "no latch" condition. Movement of the seat occupant in this condition could cause latchplate release from the buckle.

  Unbelted or incorrectly belted seat occupants aresubjected to increased risk of injury in the event of sudden stop or accident.

  Remedy

  Replace the retractor assembly for the safety belt (front and rear in coupes and front only in convertibles).

• NHTSA recall #91V031000February 19, 199121 vehicles affected

  visibility: windshield

  Poor bond adhesion between the windshield glass and the mounting, which could allow the windshield to separate from the vehicle during a collision. This fails to conform with FMVSS 212.

  If windshield separation occurs in a collision, anunbelted occupant could be ejected from the vehicle, and personal injury couldoccur.

  Remedy

  Remove all sealer from windshield and mounting; apply new bonding and sealant material, and reinstall windshield.

Other model years

• 1984 39
• 1985 46
• 1986 32
• 1987 28
• 1989 25
• 1990 25
• 1991
• 1992 88
• 1993 32
• 1994 144
• 1995 216
• 1996 116
• 1997 69
• 1998 173
• 1999 90
• 2000 76
• 2001 48
• 2002 68
• 2010 295
• 2011 194
• 2012 113
• 2013 187
• 2014 188
• 2015 206
• 2016 141
• 2017 190
• 2018 81
• 2019 53
• 2020 32