1995 Mercury Grand Marquis

Complaint history

When NHTSA received these reports. Changes in reporting alone do not establish a change in failure rates.

Problems owners report

Listed groups have at least 3 complaints. The page includes the 20 largest groups plus any additional flagged groups; some complaints are not assigned to a group.

AI groups complaints by meaning; the groups are approximate. Share ratio compares the problem’s share of this vehicle’s complaints with its share on other vehicles over the last 24 months (shown from 3 recent complaints). A 2× ratio means twice the complaint share, not twice the failure risk. Flags mark unusual shares or recent surges after an AI review of the complaint content. “First signal” does not mean the pattern has persisted continuously.How recall estimates are calculated.

Recalls

• NHTSA recall #08V051000February 4, 2008225,000 vehicles affected

  vehicle speed control: cruise control

  Ford is recalling 225,000 my 1992-2003 econoline, my 1993-1995 taurus sho, my 1992-1998 crown victoria, my 1993 bronco, f-series, my 1995-1997 f-series super duty stripped chassis, my 1992-1998 Mercury Grand Marquis, and my 1992-1995 Lincoln town car vehicles. The affected vehicles were previously repaired using a wiring harness that is not compatible with the vehicle circuit polarity.

  As a result, the fuse is located in the output circuit rather than in the intended input power feed circuit, and may not offer the intended protection in the event of an electrical short to ground.

  Remedy

  Dealers will install a new wiring harness, or replace the mating electrical component. The recall began on february 18, 2008. Owners may contact Ford at 1-800-392-3673.

• NHTSA recall #07V336000August 3, 20073,600,000 vehicles affected

  vehicle speed control

  On certain pickup trucks, passenger vehicles, sport utility vehicles, and motor homes chassis, the speed control deactivation switch may, under certain conditions, leak internally and then overheat, smoke, or burn.

  This could result in an underhood fire.

  Remedy

  Dealers will install a fused wiring harness. Owners of the passenger cars included in this campaign will be instructed to return their vehicles to their dealers to have the speed control deactivation switch disconnected as an interim repair. As soon as repair parts are available (expected october 2007), owners will be instructed to return to the dealers for installation of a fused wiring harness. The recall began on august 13, 2007, and mailing completed by september 19, 2007. Owners may contact Ford at 1-888-222-2751.

• NHTSA recall #96V045000March 5, 199649,000 vehicles affected

  seat belts: front: anchorage

  The rivets holding the rear outboard belt d-rings were not heat treated properly causing the heads of the rivets to fracture under load and fail to hold the d-rings to the straps. This does not conform to the requirements of FMVSS no. 210, "seat belt assembly anchorages."

  Consequence of non-compliance: this condition Can reduce the restraining capabilities of the safety belt in the event of an accident.

  Remedy

  Dealers will install a reinforcement plate on the rear outboard seat belt assembly anchorages involved in this campaign.

• NHTSA recall #95V189000October 2, 199545,000 vehicles affected

  electrical system: wiring: fuses and circuit breakers

  These vehicles were built with the non-cycling power window circuit breaker and the cycling headlamp circuit breaker interchanged.

  In the event of a short or overload in the headlampcircuit, both headlamps Can go out without warning, rather than flashing as intended with the cycling circuit breaker. This could lead to reduced night time driver visibility, increasing the potential for a vehicle accident.

  Remedy

  Dealers will inspect these vehicles, remove the circuit breaker and reinstall the breaker in the correct locations.

• NHTSA recall #95V063000March 27, 1995100,000 vehicles affected

  fuel system, gasoline: storage: tank assembly: filler pipe and cap

  The seal material between the fuel filler pipe and fuel tank may not have been fully cured during the molding process which could allow for fuel leakage.

  Fuel leakage could result in a vehicle fire if an ignition source were present.

  Remedy

  Dealers will replace the fuel filler pipe-to-fuel tank seal with a new seal of different material.

Other model years

• 1987 43
• 1988 73
• 1989 58
• 1990 56
• 1991 82
• 1992 255
• 1993 144
• 1994 156
• 1995
• 1996 239
• 1997 316
• 1998 143
• 1999 164
• 2000 162
• 2001 157
• 2002 78
• 2003 362
• 2004 348
• 2005 488
• 2006 143
• 2007 96
• 2008 80
• 2009 26
• 2010 25