1991 Infiniti Q45

Complaint history

When NHTSA received these reports. Changes in reporting alone do not establish a change in failure rates.

Problems owners report

Listed groups have at least 3 complaints. The page includes the 20 largest groups plus any additional flagged groups; some complaints are not assigned to a group.

AI groups complaints by meaning; the groups are approximate. Share ratio compares the problem’s share of this vehicle’s complaints with its share on other vehicles over the last 24 months (shown from 3 recent complaints). A 2× ratio means twice the complaint share, not twice the failure risk. Flags mark unusual shares or recent surges after an AI review of the complaint content. “First signal” does not mean the pattern has persisted continuously.How recall estimates are calculated.

Recalls

• NHTSA recall #98V284000November 5, 199828,970 vehicles affected

  equipment: electrical: radio/tape deck/cd etc.

  Vehicle description: passenger vehicles equipped with bose rear speakers that have an integral amplifier. A conductive bridge Can form between two lines of the circuit board pattern when there is accumulated electrolyte leaked froma capacitor and high humidity conditions. This Can close a transistor on the circuit board which causes overheating.

  This condition could result in smoke or flame and possibly the speaker catching fire.

  Remedy

  Dealers will replace the circuit board with a new board that has been coated.

• NHTSA recall #95V103002May 24, 19952,730,462 vehicles affected

  seat belts: front: buckle assembly

  The front safety belt buckle release buttons Can break. These red plastic release buttons are marked "press." if a button breaks, pieces Can fall into the buckle assembly causing the buckle to operate improperly.

  The safety belts would not provide adequate protection to an occupant in a vehicle crash.

  Remedy

  Owners should promptly check the condition and operation of both front safety belt buckles and carefully inspect the red release button for any breaks or cracks. They should ensure that both buckles are operating properly by inserting each latch plate into its buckle, tugging on the belt to make sure the latch is securely locked, and then pressing the release button. The latch plate should pop out of the buckle when the button is pressed. If either release button shows a sign of breaking or cracking or if either buckle fails to operate properly, owners should promptly contact their authorized dealer to schedule an appointment to have the buckle replaced or repaired free of charge.

Other model years

• 1990 28
• 1991
• 1992 28
• 1994 30